Installing the Bearing Guards
1. Assemble the left and right bearing guards (49 and 72) together at the top using 3/8" x 3/4" HHCS
bolts (9) and 3/8" flange nuts (21).
NOTE:
Make sure to align the access hole in the left bearing guard (49) over the grease zerk in the
bearing (50).
2. Place the assembled bearing guards (49 and 72) over the bearing (50) and fasten to the tub (27)
using 3/8" x 1" HHCS bolts (1), 3/8" flat washers (14) and 3/8" flange nuts (21) in the middle slot.
3. Install the bearing guard bottom plate (51) to the bearing guards (49 and 72) using 3/8" x 3/4" HHCS
bolts (9) and 3/8" flange nuts (21).
Figure 4-24
Installing the bearing guards
1
3/8" x 1" HHCS bolt (S-7104)
49
Left bearing guard
9
3/8" x 3/4" HHCS bolt (S-7603)
50
Bearing
14
3/8" flat washer (S-7021)
51
Bearing guard bottom plate
21
3/8" flange nut (S-8032)
72
Right bearing guard
27
Tub
42
PNEG-2309
Horizontal Fertilizer Mixer
