6
Maintenance and
Troubleshooting
Topics Covered in this Chapter
Maintaining the Auger
IMPORTANT:
For locations that will be operating, the sweep in temperatures colder than -5° Fahrenheit,
the grease in both gearboxes should be removed and replaced with 80W90 gear oil (40
fluid oz. each).
DANGER
Properly maintaining this equipment will help to ensure it continues to work
properly. Failure to properly maintain this equipment may result in damage to the
equipment or may cause SERIOUS INJURY or DEATH to the operator.
Failure to properly maintain this equipment may also be a misuse of the equipment. Any misuse
of the equipment may void the warranty.
1. The U-joint must be lubricated with SAE multipurpose grease every 10 operational hours or after
each use.
2. The upper and lower gearboxes are grease filled and do not need operational maintenance. If
repairing the gearboxes, it is recommended to fill them each with 40 fluid oz. of Mobilux EP 023
grease. If this grease is not used, 40 fluid oz. of SAE 80W90 gear oil is suggested.
3. Use caution when repairing or replacing equipment parts.
4. Make sure ALL decals are legible and tightly attached to the auger. If necessary, replace them
FREE OF CHARGE
by contacting the dealer, warehouse or the manufacturer.
5. Mount controls for any electric motors at a safe distance from the machine and in a location
accessible in case of an emergency.
6. Make sure ALL electrical wiring is not damaged and that it meets proper wiring codes.
7. Make sure ALL components are in good working condition before use.
PNEG-2108
8" and 10" Standard Duty and IW Standard Duty
61
