GSI Group PNEG-1445, Assembly & Operation Manual

Page: 41 / 60

PNEG-1445 6", 8", 10", & 12" Custom Augers 41
8. SHUTDOWN
Normal Shutdown
1. Make certain unloading tubes are empty before stopping the unit.
2. Disconnect and lockout the power source before leaving the work area.
Emergency Shutdown
1. Know how to shutdown the auger in case of an emergency.
2. Disconnect and lockout the power source.
3. Close bin well control gates.
4. Clear out as much grain from the auger and hopper as you can.
Never restart when under a full load. Starting unit under load may result in damage to the
machine. Such damage is considered abuse of the equipment.
5. Reconnect and unlock the power source.
6. Gradually clear the auger until there is no grain or obstructions.
Lockout
1. Always stop and disconnect the power source whenever the operator must leave the work
area or for maintenance of the machinery.
2. Make sure equipment is locked out and that the machinery cannot be started while the
operator is not in the work area.
Use the type of main power disconnect switch that is capable of being locked only in the
off position.
Storage Preparation
1. Close all wells to discharge auger tube.
2. Be sure the unload tube is empty.
3. Make sure power source is disconnected and locked out.
4. Check to see that all fasteners are secure.
CAUTION
WARNING