PNEG-1020 Bin Sweep Auger
19
6" and 8" Bin Sweep Assembly & Installation
2. Insert the 5/16" x 1" pin into the hole on
the sweep wheel shaft. Drive the pin into
the shaft until it is centered in the wheel
shaft.
Figure 4.9-B
3. Place two (2) steel discs onto the shaft
followed by five (5) rubber discs, followed
by two (2) steel disc.
Figure 4.9-C
4. When finished, the wheel assembly
should appear as shown.
Figure 4.9-D
5. Place one (1) 3/4" lock washer and one
(1) 3/4" nut onto the shaft and tighten.
Figure 4.9-E
4.10 Install the Motor Mount
Rods
1. Place one (1) 3/4" nuts onto each of the
motor mount rods.
Figure 4.10-A
6" Sweep
8" Sweep
Quantity
Steel
4"
5"
4
Rubber
4"
6"
5
4" Steel Disc
Total Wheel
Assembly
