GSI Group 890-00584, Installation And Configuration Manual

Page: 78 / 120

Chapter 11: Configuring a Dry Contact Zone
Figure 11-3 Graph showing a zone in an alert state followed by a 10 second recovery time
TEMPERA TURE
RECO VERY TIME = 10 SECONDS
TIME
(SECONDS)
ALERT 2
HIGH ALERT
THRESHOLD
INDOOR
T° READING
LOW ALERT
THRESHOLD
10 20 30 40 50 60
8 SECONDS
BELOW HIGH
THRESHOLD
ALERT 1 NO ALERT
RECOGNITION TIME = 0 SECONDS
14 SECONDS BEL OW
HIGH THRESHOLD
ALERT 1 IS
RESET AFTER
10 SECONDS
HIGH T° SETTING
LOW T° S ETTING
10 SECONDS
Resetting the Daily Minimum and Maximum
The system monitors and constantly updates the minimum and maximum values reached within a 24 hour
period. The time of the recorded minimum and maximum values is displayed. After 24 hours, the values
are reset and the monitoring starts anew.
In status mode, under the General tab in the zone you are configuring, click on the Reset min/max .
The information beside the Max 24h and Min 24h buttons is reset.
Choosing the Type of End of Line Resistor
When configuring a zone using end of line resistors, you must choose the type of end of line resistors used
in your installation for the zone you are configuring to ensure data accuracy.
1. In edit mode, under the General tab, click on the edit field next to EOLR .
2. Select the type of resistor you are using.
Selecting the Type of Contact in the Dry Contact Zone
1. In edit mode, under the General tab, click on the edit field next to the Contact button.
2. Select the contact type used for the zone.
78 895-00677 Agri Alert 128 Touch