Gryphon Zena, Owner'S Manual

Page: 8 / 24

8
Manufacture and Assembly
At our laboratories and manufacturing facilities in Denmark, we
maintain full control over every aspect of development and
production, and the members of our conscientious staff diligently
follow each Gryphon model from initial concept to early prototype,
through to final quality control.
Printed circuit boards are assembled by a supplier of precision
military and medical equipment with strict standards of quality control
and pre-inspection of components. Chassis parts are manufactured
by a specialist chosen solely for the outstanding quality of
workmanship. In every aspect of every Gryphon product, the same
stringent standards of excellence apply.
Each unit is individually tested, after a 48-hour burn-in sequence,
each product is undergoing both electronically and audio
performance tests again.
Placement:
Do not place the Zena on or near any source of heat such as power
amplifiers. Do not place any object on the top covering the ventilation
holes of the Zena. Do not place the Zena in an enclosed space such
as a cabinet unless ample ventilation is provided. If these guidelines
are not observed, overheating may result.
Mains Switch:
To power your Zena fully ON/OFF use the main switch. The switch is
located in the bottom on the right side just beneath the acrylic front
panel.
AC Voltage
Your Gryphon unit is especially made for the AC voltage of the
country to which it has been shipped. If the voltage has been
changed, the warranty is void and the product may be unsafe or
malfunction.
Correct AC polarity contributes greatly to optimum performance. If
you are not using a three-pin, non-reversible power plug, please
experiment with the orientation of the plug for optimum performance.
The main ON/OFF switch on the
Zena is placed on the bottom right
side of the unit near the front.
If the blue LED to the left of the
ON/STD symbol is flashing 3 times
in STB mode, it indicates wrong
/defective AC mains voltage.
SAFETY
INSTRUCTIONS