®
Gryphon
Diamond
Wire-Saw
made in
U.S.A.
Oil both 1/4" shafts frequently
Do not run with cover off
Wear Eye Protection
Patent Pendin
g
Instructions
Gryphon Diamond Wire Saw
model Omni-1
• Always wear eye protection •
• Do not run blade dry- use plenty of water •
• Keep fingers clear of moving parts •
• Do not operate with finger guard removed •
• Do not operate with front cover removed •
Important - Fill Base completely with water before use
Front
Cover
Motor Housing
Motor
Switch
Light
Switch
Upper
Blade
Guide
Fresh
Water
Reservoir
Base
Platform
Fresh
Water
Valve
Right Side of Saw
Barbed Fitting
Fresh
Water
Fill Spout
Used
Water
Valve
Used Water
Drain Barbed Fitting
Left Side of Saw
Fresh Water Feed Tube
Vertical
Shafts
Blade
Chuck
Connecting
Rod
Aluminum
Block
Lower
Wrist
Pin
Upper
Wrist
Pin
Gryphon Wire Saw Parts Identification
Motor Assembly
Assembly Step 1
Turn the base of your saw upside down. Push the long piece of tubing from your parts
bag onto the barbed fitting. Tubing inside diameters vary widely from batch to batch and
from manufacturer to manufacturer. Soaking one end of your tubing in hot water helps to
overcome a too-tight fit.
Insert tube onto barbed fitting
Assembly Step 2
Place motor assembly on top of base. Slip a plastic washer onto each of the two
plastic thumbscrews found in your parts bag. Insert thumbscrews into blue grom-
mets at the upper outside corners of the water tray. Tighten screws into motor
assembly snug tight only.
