Keep a copy of warnings to install for the photovoltaic modules in the immediate vicinity o f t h e
photovoltaics plant.
Do not disassemble the
GruppoSTG Fabbrica Srl
module or remove its components, labels or parts
applied by the manufacturer, including protection diodes .
Do not artificially concentrate the sunlight to direct it on the
GruppoSTG Fabbrica Srl
module to avoid the
danger of fire or malfunctioning problems .
The
GruppoSTG Fabbrica Srl
modules are supplied in packaging the appropriate waves ensure proper protection
in transport. It is recommended to not remove them from the packaging until no is installed.
Do not transport the
GruppoSTG Fabbrica Srl
module by
grasping the connection cables or the junction
box to avoid the risk of electric shocks and injury or damage to the product.
Check the mechanical integrity of the
GruppoSTG Fabbrica Srl
module before installation. Use only
intact modules . Do not install damaged photovoltaic modules .
Keep the
GruppoSTG Factory Srl
module always plan (not bend, turn , or the like).
To avoid the risk of injury, such as accidental fall of the
GruppoSTG Fabbrica Srl
module on a foot or cuts
caused by sharp edges, the handling of the
GruppoSTG Fabbrica Srl
module must be performed by at
least two persons using the frame for the outlet. Always use non-slip gloves .
Do not let fall the PV modules. Do not let it drop anything on the them. Do not remain standing or to walk
over to avoid the risk of injury and damage to the
GruppoSTG Fabbrica Srl
module
.
Do not treat the rear side of the
GruppoSTG Fabbrica Srl
module with paints or adhesive glues .
Do not leave never a
GruppoSTG Fabbrica Srl
module
no structure to support or not secured in safety.
Do not use modules that may suffer shocks or other damage during assembly. A
GruppoSTG Fabbrica Srl
module with broken glass or with a damaged rear insulating sheet cannot be repaired and must no longer
be used. Lightning risk.
Make sure that the structure intended to support the modules on the roof is correctly sized. For roof
additions, compliance with specific indications necessary to provide correct installation may be required .
Both the roof structure and the installation of the
GruppoSTG Fabbrica Srl
module contribute to the value
of the building's fire resistance. Incorrect installation can contribute to an increased risk in the event of a
fire. In addition to a preventive design risk assessment, please note that it may be necessary to use
additional protection devices such as earth fault protection, fuses and emergency release devices to
disconnect the system
Do not use the
GruppoSTG Fabbrica Srl
module for uses other than those envisaged. Use the
GruppoSTG
Fabbrica Srl
modue
l
only for the use which is intended.
Do not install the
GruppoSTG Fabbrica Srl
module in the vicinity of easily flammable gases or vapors , in
order to avoid the formation of sparks.
