Grundig GW781041FW, User Manual

Page: 11 / 48

11 / EN
Washing Machine / User Manual
Cap
Insert the cap by pushing it with your finger.
4.1.3 Removing transportation safety bolts
1 Loosen all transportation safety bolts with an appropriate wrench until they turn freely.
2 Stretch the internal component by pressing on the holding areas and pull the component out.
3 Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel.
WARNING
Remove the transportation safety bolts before operating the product! Otherwise, the product will get damaged.
WARNING
Keep the transportation safety bolts in a safe place to reuse when the product needs to be moved again in the future.
Install the transportation safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
4.1.4 Connecting to water supply
WARNING
Models with a single water inlet shall not be connected to the hot water tap. In such a case the laundry will get damaged or
the product will switch to protection mode and will not operate.
Do not use old or used water inlet hoses on a new product. It may cause water leakage from your machine and stain your
laundry.
1 Tighten all hose nuts by hand Never use a tool when tightening the nuts.
2 Open the taps completely after making the hose connection to check for water leaks at the connection
points. If any leak occurs, turn off the tap and remove the nut. Check the gasket and tighten the nut
carefully again. In order to prevent the water leaks and resultant damages, keep the taps closed when
you do not use the product.