Grundig GW75843TW, User Manual

Page: 5 / 48

5 / EN
Washing Machine / User Manual
u
Carry the product in an upright position.
u
Make sure that the hoses as well as the power cable are not folded, pinched
or crushed after the product is fitted into its place after installation or
cleaning procedures.
A
1.5 Installation Safety
u
Check the information on the manual and installation instructions to prepare
the product for installation and make sure the electrical mains, clean water
mains and water outlet are suitable. If not, call a qualified electrician and
plumber to have them make the necessary arrangements. These operations
are the responsibility of the customer.
u
Check for any damages before installing the product. Do not go ahead with
the installation if the product is damaged.
u
Injuries may occur if hands are put into uncovered slots. Close the holes of
the transportation safety bolts with plastic plugs.
u
Do not install or leave the product at locations where it may be exposed to
external environment conditions.
u
Do not install the product at locations where the temperature drops below
0ºC.
u
Do not place the product on a carpet or similar surface. It would create fire
hazard since it cannot receive air from underneath.
u
Place the product on a clean, even and hard floor and balance with the
adjustable feet.
u
Connect the product to a grounding plug protected by a fuse suitable to the
current values on the type label. Make sure the grounding is carried out by
an expert electrician. Do not use the product without suitable grounding to
local/national regulations.
u
Plug the product in a socket with voltage and frequency values suitable to
those indicated on the type label.
u
Do not plug the product in loose, displaced, broken, dirty, oily sockets or
sockets with risk of water contact.
u
Use the new hose set provided with the product. Do not re-use old hose
sets. Do not make additions to the hoses.
u
Connect the water inlet hose directly to the water tap. The pressure from the
tap should be minimum 0.1 MPa (1 bar) and maximum 1MPa (10 bars). 10
to 80 litres of water should be running from the tap in a minute in order for
the product to function properly. If the water pressure is above 1 MPa (10
Bars), a pressure-reducing valve should be fitted. The maximum allowed
temperature is 25°C.