Grundig GTN 38250 TGCW, User Instructions

Page: 36 / 44

36
9 Electrical
Connection
Make sure that you have an earthed
power outlet socket rated at 13 amps
(minimum).
9.1 Attention!
When installed, the socket must
be reachable after installation,
or a separate switch (which can
disconnect the two poles) must be
used in the installation. Check for
suitability.
For a permanent connection, a
master switch with at least 3mm
contact clearance and minimum 13 A
rating must be used.
9.2 Electrical requirements
Before you insert the plug into the
wall socket make sure that the
voltage and the frequency shown in
the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in
a readily accessible position.
Should the mains lead of the
appliance become damaged or
need replacing at any time, it must
be replaced by a special purpose
made mains lead which can only be
obtained from an Authorised Service
Agent.
A
Warning
This appliance must be earthed
If the fitted moulded plug is not
suitable for your socket, then
the plug should be cut off and an
appropriate plug fitted.
The moulded plug on this appliance
incorporates a 13A fuse. Should the
fuse need to be replaced an ASTA
approved BS1362 fuse of the same
rating must be used. Do not forget
to refit the fuse cover. In the event of
losing the fuse cover, the plug must
not be used until a replacement fuse
cover has been fitted. Colour of the
replacement fuse cover must be the
same colour as that visible on the
pin face of the plug. Fuse covers are
available from any good electrical
store.
In order to avoid hazards, damaged
supply cord should be replaced by
the manufacturer, its service agent or
similarly qualified people.
A Do not operate without the top
cover fitted. Risk of injury.
A
Important
9.3 Fitting a different plug
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
on your plug, proceed as follows:
1 Connect the green - yellow or
green (earth) wire to the terminal
in the plug marked ‘E’ or with the
symbol or coloured green and yellow
or green.
2 Connect the blue (neutral) wire to
the terminal in the plug marked ‘N’
or coloured black.