9
TR
3
Installation
3.1 Appropriate installation
location
Contact an Authorized Service for
the installation of the product. In
order to prepare the product for use,
refer the information in the user
manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified
electrician and technician to have
any necessary arrangements carried
out.
B
WARNING:
Manufacturer shall not be
held liable for damages
that may arise from
procedures carried out by
unauthorized persons.
B
WARNING:
Product
must not be plugged
in during installation.
Otherwise, there is the
risk of death or serious
injury!
A
WARNING:
If the door
clearance of the room
where the product shall be
place is so tight to prevent
passing of the product,
remove the door of the
room and pass the product
through the door by
turning it to its side; if this
does not work, contact the
authorized service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves and
at least 5 cm away from electrical
ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Your product requires adequate air
circulation to function efficiently.
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between the
product and the ceiling, rear wall
and the side walls.
• If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling,
rear wall and the side walls.
Check if the rear wall clearance
protection component is present
at its location (if provided with
the product). If the component
is not available, or if it is lost or
fallen, position the product so that
at least 5 cm clearance shall be
left between the rear surface of
the product and the wall of the
room. The clearance at the rear is
important for efficient operation of
the product.
• Do not install the product in places
where the temperature falls below
-5°C.
