Power Connection for GCI-K0503B and GCI-H0503B:
Please refer to section 4.1. Camera Overview for power wiring. Additionally, if using PoE, make sure Power
Sourcing Equipment (PSE) is in use in the network.
4.5. Ethernet Cable Connection
Use of Category 5 Ethernet cable is recommended for network connection; to have best transmission quality,
cable length shall not exceed 100 meters. Connect one end of the Ethernet cable to the RJ45 connector of the IP
Camera, and the other end of the cable to the network switch or PC.
NOTE: In some cases, you may need to use an Ethernet crossover cable when connecting the IP Camera directly
to the PC.
Check the status of the link indicator and the activity indicator LEDs; if the LEDs are unlit, please check the LAN
connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
4.6. Alarm Application
The camera is equipped with one alarm input and one relay output for alarm application. Please refer to the
alarm pin definition below for the connection of alarm devices to the IP Camera if needed.
PIN 1:
PIN 2: Output-
PIN 3: Input+
PIN 4: Input-
Additional for GCI-H0503B with RS-485 Interface:
PIN 5: GND
PIN 6: D-
PIN 7: D+
NOTE: The RS-485 Interface in the model GCI-H0503B is an interface for connecting the camera with a pan & tilt
positioning system (please refer to chapter 12. Pan/Tilt for more information).
5
English
Summary of Contents for GCI-H0503B
Page 2: ......
