GRUNDIG Service
1 - 15
Allgemeiner Teil / General Section
CUC 7303
Operating Hints
This chapter contains excerpts from the operating instructions. For further particulars please refer to the appropriate user
instructions the part number of which is indicated in the relevant spare parts list.
10
SETTINGS
__________________________________________________________________________
Assigning Channel Positions with the ATS Automatic Channel Search
and Memory System
The television set is equipped with an automatic channel search system.
You start the search and can then sort the television channels into order of preference.
There are 69 channel positions available which as required can be assigned television channels
from the aerial or from the cable connection.
You can also delete television channels from the channel list which were found more than once or
which have poor reception.
1
Switch the television set on with the »
I O
« button on the television set.
– »ATS« is displayed on the screen.
Note:
If »ATS« is not displayed, press »AUX« for approx. 4 seconds until the display appears.
2
Start the ATS search with the »
OK
« button.
– The ATS search procedure can take over a minute.
– Once the television set has stored all television channels it will switch to channel position 1.
Note:
Further settings – such as deleting unwanted television channels or changing the order of
television channels later – are described on the next page.
Details of limiting the channel position selection and manually inputting television channels can
be found in the ”SPECIAL SETTINGS” chapter on Page 21.
ATS
■
OK
ATS
■
ENGLISH
9
OPERATION ON THE TELEVISION SET
_______________________
Switching on/off
1
Switch on the television set with the »
I O
« button.
– If the display lights up, the television set is in stand-by mode.
2
Switch on the television set completely with the »
P+
« button.
3
Switch the television set off with the »
I O
« button.
Adjusting volume
1
Adjust the volume using the »
–
z
+
« buttons.
Selecting the channel
1
Select the channel using the »
– P+
« buttons.
y
P
