Grundig 43 VLE 5523 BN, User Instructions

Page: 72 / 82

ENGLISH
72­
Skipping­television­channels
You can highlight television channels to be
skipped when you select with »
Λ
« or »
V
«.
Selection is still possible using the number
buttons.
1­
In the »PROGRAME TABLE« menu, switch
over to the list view with »

« (yellow).
2­ Select the preferred channel with »
V
«
or »
Λ
«.
3­ Select the column »Skip« with »
<
« or »
>
«
and use » OK « to mark the channel.
– The channel is marked using »
✔
«.
Note:
7
Channels can also be reactivated. Select
the channel with »
V
« or »
Λ
«, then select
the column »Skip« and reactivate the chan-
nel with »
OK
«.
Creating­lists­of­favourites
You can select your favourite channels and
save them in up to four favourites lists (Fav 1 to
Fav 4).
1­ In the »PROGRAME TABLE« menu, switch
over to the list view with »

« (yellow).
2­
Select the preferred channel with »
V
«
or »
Λ
«.
3­ Use »
<
« or »
>
« to ”push“ the channel into
one of the favourites lists 1 to 4 and press
» OK « to confirm.
– The position in the favourites list is marked
with »
✔
«.
– You can enter the same channel in more
than one favourite list.
– Each favourite list can store up to
250 channels.
Note:
7
Channels can also be deleted from favou-
rites lists. Select the channel to be deleted
with »
V
«, »
Λ
«, »
<
« or »
>
« and delete it
with »
OK
«.
Exiting­the­settings
1­ Press » MENU « to end the setting.
SETTING­FURTHER­CHANNELS
­-----------------------------------------------------
Displaying­signal­information
(for digital channels only)
1­ Open the menu with » MENU «.
2­ Select the menu item »SOURCE SETUP«
with »
V
« or »
Λ
« and press » OK « to
confirm.
3­
Select the line »Signal Information« with
»
V
« or »
Λ
« and press »
OK
« to confirm.
– Information on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
7
The signal information changes in ac cord-
ance with the current input source.
7
The signal properties are displayed in the
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
7
The signal level not only depends on your
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
4­ Press » MENU « to close the menu.