6.38 "Connection code"
Use the connection code to enable automatic connection between Grundfos GO Remote and the product. Thus, you do not need to
press
OK
or the
Radio communication
button each time.
You can also use the connection code to restrict remote access to the product.
You can only set the connection code with Grundfos GO Remote.
6.38.1 Setting a connection code in the product by using Grundfos GO Remote
1.
Connect Grundfos GO Remote to the product.
2.
Go to
Settings
>
Connection code
.
3.
Enter a connection code and press
OK
.
You can change the code in the
Connection code
menu at any time. The old code is not required.
6.38.2 Setting a preset connection code in Grundfos GO Remote
You can set and store a preset connection code in Grundfos GO Remote so that it automatically connects to products with an identical code.
1.
Open Grundfos GO Remote.
2.
Press the
Menu
icon in the upper left corner of Grundfos GO Remote.
TM070084
3.
Go to
General
>
Settings
>
Remote
.
4.
Enter the preset connection code in the
Preset connection code
field and press
OK
.
To change the preset connection code, press
Delete
and enter a new one.
To activate the connection code, restart the product.
If Grundfos GO Remote fails to connect and asks you to press
OK
or the
Radio communication
button on the product, the product has no
connection code or has a different connection code. In this case, press
OK
or the
Radio communication
button to establish connection.
6.39 "Run start-up guide"
The function is only available in the advanced operating panel.
The startup guide automatically starts when you start the product for the first time. You can always run the startup guide later. The startup
guide guides you through the general settings of the product.
To run the startup guide, go to
Settings
>
General settings
>
Run start-up guide
.
6.40 "Alarm log"
This function contains a list of logged alarms from the product. The log shows the alarm code, name of the alarm, when the alarm occurred
and when the alarm was reset.
6.41 "Warning log"
This function contains a list of logged warnings from the product. The log shows the warning code, name of the warning, when the warning
occurred and when the warning was reset.
6.42 "Assist"
This menu consists of a number of different assist functions.
Assist functions are small guides that take you through the steps needed to set the product.
6.43 "Assisted pump setup"
This function guides you through the following:
Setting the motor
•
Selection of control mode
•
Configuration of feedback sensors
•
Adjustment of the setpoint
•
Controller settings
•
Summary of settings.
With Grundfos GO Remote, access the
Assisted pump setup
menu.
56
English (GB)
Summary of Contents for RADIOMODULE 2G4
Page 2: ......
