Grundfos RADIOMODULE 2G4, Installation And Operating Instructions Manual

Page: 34 / 76

Settings MGE Multimotor system
Relay output 2 • •
Analog output
*
• •
Output signal
* • •
Function of analog output
*
• •
Controller settings • •
Operating range • •
Setpoint influence • •
Ext. setpoint infl. • •
Predefined setpoints
*
• •
Monitoring functions • •
Motor bearing monitoring • •
Alarm handling
Motor bearing maintenance • •
Limit-exceeded function • •
Special functions • •
Stop at min. speed
Ramps • •
Standstill heating • •
Direction of rotation
Communication • •
Pump number • •
Enable/disable radio comm. • •
General settings • •
Language • •
Set date and time • •
Units • •
Enable/disable settings • •
Delete history • •
Define Home display • •
Display settings • •
Store actual settings • •
Recall stored settings • •
Run start-up guide • •
* Only available if an advanced functional module, type FM 300, is fitted.
Assist MGE Multimotor system
Assisted pump setup • •
Setup, analog input • •
Setting of date and time • •
Setup of multi-pump system • •
Description of control mode • •
Assisted fault advice • •
Related information
6. Setting the product
5.2 Grundfos GO Remote
The product is designed for wireless radio or infrared communication with Grundfos GO Remote.
34
English (GB)