English (GB)
5
Lifting point, top
KPL and KWM: Use the lifting bracket as the top
lifting point. See fig.
.
KPG: Use two top lifting points. See fig.
.
Lifting point, centre (KPG)
When installing KPG pumps horizontally, use the
lifting points on the outlet casing, see fig.
Lifting point, bottom
Use the pump inlet casing as the bottom lifting point.
Lift by means of a lifting strap or a lifting chain
secured around the pump inlet casing. See fig.
fig.
Fig. 2
KPL and KWM: anti-rotation brackets
Fig. 3
KPG: anti-rotation brackets
3.2.1 Lifting with single or double wire
Lifting with single wire
Fig. 4
KPL and KWM: lifting with single wire
Fig. 5
KPG: lifting with single wire (for
transport)
Fig. 6
KPG: lifting with single wire connected
to both lifting eyes (for installation)
Do not lift the pump by the anti-rotation
brackets.
T
M
05
9
2
0
9
33
13
TM
07
46
8
5
22
19
TM
05
9
207
33
1
3
TM
07
46
8
6
22
19
T
M
07
4
7
9
9
22
19
During installation, the KPG motor top is
inserted into the gate flange. Therefore,
only the lifting method shown in fig.
can
be used for installation.
The lifting eyes in the outlet casing are
close to the centre of gravity, so the pump
can be lifted in horizontal position without
using the lifting eyes on the motor top.
