6
2. Safety
2.1 Instructions for the operator
2.1.1 General information
All our pumps are carefully packed before they leave our
warehouse to avoid damage during transport.
Unpacking
If, after carefully unpacking and inspecting the shipment, you
find damage, you must promptly inform the shipping agent.
Storage
If the pump is not put into service immediately, it is important
that it is stored properly to ensure that it will function correctly
later. This is just as important as proper installation and
maintenance.
The pump must be protected from cold, moisture, and dust as
well as from mechanical influences.
Specially trained personnel are required to install and
maintain the pump properly.
2.2 Safety instructions in the
operating manual
Read safety instructions!
The operating manual contains all the basic information
required for the set-up, operation, and maintenance of the
pump. The installer as well as the technical personnel or
operator responsible for the pump must therefore read this
manual before installing and starting the pump. The operating
manual must always be available at the site where the pump
is being used. Both safety instructions presented in this
section and the specific safety instructions in later sections
must be followed.
2.3 Identification of instructions in
the operating manual
Symbol
The safety instructions presented in this operating manual are
identified as shown below.
Signal words
In order to classify the safety labels they are distinguished by
the following signal words:
•
Danger
Characterises an imminent hazard with a high risk which
can cause death or grievous bodily harm.
Overview
This section describes what you have to consider for your own safety. The structure and identification of safety
instructions is described. Read this important section attentively!
Fig. 1
Symbol for safety instructions
A: Failure to follow these safety instructions can endanger per-
sonnel.
B: Safety instructions which involve warnings against electrical
voltage.
C: Failure to follow these safety instructions can endanger the
machine and its operation.
K
.0319
V1 |
K
.0320
V1
ATTENTION
A
B
C
!
