8. Control functions
The display contrast can be adjusted by pressing [Status]
and then pressing [Up] or [Down].
8.1 Operating panel
The operating panel consists of a display and several buttons. It
enables manual setting and monitoring of the system, such as
follows:
•
Start, stop and control of speed.
•
Reading of operating data and warnings and alarms.
•
Setting functions for the frequency converter.
•
Manual reset of the frequency converter.
1
AUTO
ON
RESET
HAND
ON
OFF
Status
1(1)
36.4 kW
Auto Remote Ramping
0.000
ON
ALARM
WARN.
7.83 A
799 RPM
53.2 %
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
TM074597
Operating panel
Pos.
Buttons
Description
1
Power [kW]
2
Reference [%]
3
[Alarm log]: shows a list of current
warnings, the last 10 alarms and the
maintenance log.
4
[Main menu]: allows access to all
programming settings.
5
[Cancel]: cancels the last change or
command as long as the display mode
has not changed.
6
[Info]: press for a definition of the
function being displayed.
7
[Up]/[Down]/[Left]/[Right]: use the four
arrow buttons to navigate between
items in the menu.
8
OK
: used to access parameter groups
or to accept a selection.
9
RESET
RESET
: resets the frequency converter
manually after a fault has been cleared.
Pos.
Buttons
Description
10
AUTO
ON
AUTO ON
: puts the system in remote
operating mode.
• Responds to an external start
command by control terminals or serial
communication.
11
OFF
OFF
: stops the motor, but does not
remove power to the frequency
converter.
12
HAND
ON
HAND ON
: starts the frequency
converter in local control.
• An external stop signal by control
input or serial communication overrides
the local
HAND ON
function.
13
ALARM
Red
A fault condition causes the red alarm
light to flash, and an alarm text is
displayed.
14
WARN.
Yellow
When warning conditions are met, the
yellow warning light comes on and text
appears in the display area identifying
the problem.
15
ON
Green
The
ON
light activates when the
frequency converter receives power
from the mains voltage, a DC bus
terminal or an external 24 V supply.
16
[Back]: reverts to the previous step or
list in the menu structure.
17
[Favourites]: allows access to
programming parameters for initial
setup instructions and many detailed
application instructions.
18
[Status]: shows operating information.
19
Frequency
20
Motor current
21
Speed, RPM
Related information
8.2 Menu overview
Overview of the main menus. The ** represents a number to a
submenu.
Press
OK
to select a menu and use the [Up] and [Down] buttons to
navigate in the menus.
Example:
To get to the menu
1-28 Motor Rotation Check
, you
must do the following:
1. Navigate to
1-** Load and Motor
, and press
OK
.
2. Use the [Up] and [Down] buttons to navigate to
1-2* Motor
Data
, and press
OK
.
3. Use the [Up] and [Down] buttons to navigate to
1-28 Motor
Rotation Check
, and press
OK
to select the menu.
Related information
23
English (GB)
