Grundfos CMEC, Installation And Operating Instructions Manual

Page: 29 / 42

English (GB)
29
7. Connect the cable screens of the bus cables to
protective earth via one of the earth clamps (fig.
36 , A).
Fig. 36 Connecting the cable screens to
protective earth
8. Route the wires for the CIM module. See the
example in fig. 37 .
Fig. 37 Example of wire routing
9. Fit the CIM cover.
10. If the CIM module is supplied with an FCC label,
then place this on the terminal box. See fig. 38 .
Fig. 38 FCC label
11. Fit the terminal box cover (fig. 32 , B) and
cross-tighten the four mounting screws (fig. 32 ,
A) to 6 Nm.
18. Changing the position of the
operating panel
You can turn the operating panel 180 °. Follow the
instructions below.
1. Loosen the four screws (TX25) of the terminal
box cover.
Fig. 39 Loosening the screws
TM
06
419
5
161
5
TM
06
40
85
15
15
TM
05
7
028
04
1
3
A
FCC
Make sure that the terminal box cover is
aligned with the operating panel. See
section
18. Changing the position of the
operating panel
.
DANGER
Electric shock
Death or serious personal injury
- Switch off the power supply to the motor
and to the signal relay. Wait at least 5
minutes before starting any work on the
motor. Make sure that the power supply
cannot be accidentally switched on.
TM
05
5
351
36
1
2