Page 18 of 40
Single Phase FireSAFE must be connected to the mains power as shown below:
First the flaps on the side of the control panel need to be opened, this will allow access to the
screws needed to remove the front panel. The ‘pump out’ connection will be wired in from the
factory. On insulation the ‘mains power in’ connections need to be wired as shown below.
Figure 9 Single Phase mains power cabling instructions
Three Phase FireSAFE must be connected to the mains power as shown below:
Figure 10 Three Phase mains power cabling instructions
First loosen the 6 screws needed
to remove the panel cover.
The ‘pump’ connections will be
wired in from the factory. On
insulation the ‘mains input’
connections need to be wired as
shown to the left.
Summary of Contents for 97931710
Page 22: ...www grundfos co uk Page 22 of 40...
Page 37: ...www grundfos co uk Page 37 of 40...
Page 38: ...www grundfos co uk Page 38 of 40...
