English (GB)
5
3.4 Electrical connection
• The motor requires no external motor protection.
• Check that the supply voltage and frequency correspond to
the values stated on the nameplate. See section
• Connect the pump to the power supply with the plug supplied
with the pump. See steps 1 to 7.
3.4.1 Assembling the installer plug
DANGER
Electric shock
Death or serious personal injury
- All electrical connections must be carried out by a
qualified electrician in accordance with local
regulations.
DANGER
Electric shock
Death or serious personal injury
- Switch off the power supply before starting any
work on the product. Make sure that the power
supply cannot be accidentally switched on.
DANGER
Electric shock
Death or serious personal injury
- Connect the pump to protective earth.
DANGER
Electric shock
Death or serious personal injury
- In case of an insulation fault, the fault current may
be a pulsating DC. Observe national legislation
about requirements for and selection of Residual
Current Device (RCD) when installing the pump.
The pump is not a safety component and cannot be
used to ensure functional safety in the final
appliance.
Step Action
Illustration
1
Loosen the cable
gland and
unscrew the union
nut in the centre
of the terminal
cover.
TM
06
85
4
2
09
18
2
Detach the
terminal cover.
T
M
0
6
8
54
3
0
9
1
8
3
Pull the power
cable through the
cable gland and
terminal cover.
T
M
06
8
5
4
4
09
1
8
4
Strip the cable
conductors as
illustrated.
TM0
6
854
5
091
8
5
Loosen the
screws on the
power supply plug
and connect the
cable conductors.
TM
0
6
8
546
0
918
-
TM
0
6
85
47
09
18
6
Tighten the
screws on the
power supply
plug.
TM
06
854
8
091
8
0/Off
1/On
42 mm
32 mm
Ø 5.5 - 10 mm
0.5 - 1.5 mm
2
8 mm
L
PE
N
x 3
x 3
