12
Maintenance
7. Unscrew seat 1/8 to 1/6 turn (45
°
to
60
°
), see Fig. [17].
8. Slide valve on the supplies, see Fig. [18]
9. Tighten set screw (D1) and compression
nuts.
10. Push on stop ring (T) with catch (T1)
on top.
11. Reinstall cover ring (S) with mark (S1)
on top.
12. Push on adapter (R).
13. Push on shut-off handle (Q) in closed
position.
14. Reinstall washer (Q2) and fix with cir-
clips (Q1), the smaller one is cloth to the
shut-off handle.
15.Push on scale ring (P) with
0
on top and
fix with clip (P1).
16.Reinstall the temperature handle (O) in
position hot water.
17. Fix temperature handle with screw (N)
and cover with cap (M).
Readjustment is necessary after every
maintenance operation on the control unit,
see chapter
“Adjustment”
on page 10.
II.Non-return valve,
see spare parts
drawing on page 3, 4. and Fig. [13].
1.Same procedure as for control unit, see
Fig. [13], points 1, 11 and 12.
2.Unscrew elbow, see spare parts drawing
on page 3 and 4.
3.Remove threaded ring with flow
limiter if installed.
4.Take out and replace non-return
valve.
Reassemble in reverse order.
Only genuine GROHE replacement parts
must be used.
17
45
°
-60
°
18
M
N
S
T
O
2.5
mm
24
mm
R
T1
S1
Q
Q1
D1
Q2
P1
P
Summary of Contents for Avensys 34 084
Page 3: ...II Spare Parts 3 4...
Page 13: ...14...