Things you should know
42
In case you will not be using this product for a long time
How to drain the water
In the following cases be sure to drain the water according to the steps below. Turn off the power breaker or remove the
power plug from the outlet.
•
If the toilet will not be used for a long time due to travelling etc. (It may cause clogging due to dirty water.)
•
If the toilet is installed in an unoccupied house, such as a villa, there is a danger of freezing due to an unexpected
temperature drop.
1. Close the water shutoff valve and stop the water feed.
If the open/close handle is hard to turn, turn it while holding it with a dry towel.
2. Drain the water from the unit.
1. Press the
(set/next)button repeatedly until the [SETTING 5] screen appears.
2. Press the button below [AUTOMATIC DRAIN].
Drain the remaining water in the seat unit for 2 minutes.
3. Drain the water from the water supply hose.
1. Remove the water supply hose on the side of water shutoff valve.
• A small amount of water spills at this time.
• Insert the flat-blade screwdriver into the space of the clip and push the screwdriver into the base of box-shaped
part, then push it forward and open the tab.
• It will be easier if you push the screwdriver while twisting a little.
2. Press the
(flush/full) button and drain the water (approx. 100cc) from the water supply hose.
Water shutoff
valve
Open/close
handle
Close
Space of
the clip
Flat-blade screwdriver
Lock part
The hooked tab
gets caught on
the internal
structure of the
lock part.