Model T32957 (Mfd. Since 09/21)
-15-
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Figure 11. Front extension arms attached.
x 4
Front Extension
Arm (1 of 2)
To assemble machine:
1. Use level to check shear table.
— If table
is
level, no adjustment is required.
Proceed to
Step 2.
— If table
is not
level, use shims between
floor and base to level machine before
proceeding. Leveling shear helps blades
and other components remain straight and
flat during life of machine so machine can
continue to cut straight and square.
2. Cut cable ties securing foot pedal to table.
3. Have another person press and hold foot
pedal about halfway through full range of
movement.
4. Insert (2) 12 x 45mm clevis pins in holes in
foot pedal frame and secure with (2) M3 x 50
cotter pins, as shown in
Figure 10.
Figure 10. Location of hole in foot pedal frame
(1 of 2 shown).
x 2
Note:
Arm
T-slots must line up with table
T-slots, and surfaces must be flush (see
Figure 12
).
Figure 12. Extension arm T-slot lined up with
table and flush with table surface.
6. Install (1) M12-1.75 x
45 T-bolt in each T-slot
and secure front work stop to extension arms
using (2) 12mm flat washers and M12-1.75
wing nuts (see
Figure 13).
Figure 13. Front work stop secured to extension
arms.
x 2
Front
Work Stop
Extension Arm
(1 of 2)
5. Attach (2) front extension arms to shear table
with (4) M12-1.75 x 30 hex bolts and 12mm
flat washers (see
Figure 11).
Summary of Contents for T32957
Page 36: ......
