Always operate lathe with tailstock firmly
locked to bed. Serious personal injury may
occur if tailstock moves during operation.
Figure 12. Location of tailstock clamp nut.
Figure 11. Location of tailstock lock lever.
-18-
Model T32536 (Mfd. Since 10/20)
Workpiece Inspection
Some workpieces are not safe to turn or may
require modification before they are safe to turn.
Before turning, inspect all workpieces for the
following:
•
Workpiece Type:
This machine is intended for turning natural
wood products. Never attempt to turn any
composite wood materials, plastics, metal,
stone, or rubber workpieces; turning these
materials can lead to machine damage or
severe injury.
•
Foreign Objects:
Nails, staples, dirt, rocks and other foreign
objects are often embedded in wood. While
cutting, these objects can become dislodged
and hit the operator, cause tool grab, or break
the turning tool, which might then fly apart.
Always visually inspect your workpiece for
these items. If they can't be removed, DO
NOT turn the workpiece.
•
Large/Loose Knots:
Loose knots can become dislodged during
the turning operation. Large knots can cause
a workpiece to completely break in half
during turning and cause machine damage
and injury. Never turn workpieces that have
large/loose knots.
•
Excessive Warping:
Workpieces with excessive bowing or twist-
ing are unstable and unbalanced. Never turn
these workpieces at high speed, or instability
will be magnified and the workpiece can be
ejected from the lathe causing injury. Only
turn concentric workpieces!
•
Wet or "Green" Stock: Turning wood with
a moisture content over 20% can cause
increased wear on tooling.
Adjusting Tailstock
The tailstock is equipped with a cam-action
clamping system to secure it to the lathe bed.
When the lever is tightened, a locking plate lifts up
underneath the bed and secures the tailstock in
place. The tailstock can be positioned anywhere
along the lathe bed.
2. Retighten tailstock lock lever to secure
tailstock to bed.
Note: Clamping hex nut underneath tailstock
(see
Figure 12) requires occasional adjust-
ing to ensure proper clamping of tailstock to
bed. Turn this hex nut in small increments to
fine-tune clamping pressure as needed.
Tailstock
Lock Lever
To position tailstock along length of bed:
1. Loosen tailstock lock lever and move tailstock
to desired position along bed (see
Figure 11).
Tailstock
Clamp Nut
Summary of Contents for T32536
Page 44: ......
