Grizzly T32304, Owner'S Manual, Page: 15 / 52

NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 5. Model T32304 Saw Body.
Figure 6. Stand and motor inventory.
Figure 7. Table and hardware inventory.
Model T32304 (Mfd. Since 02/21)
-13-
Inventory
Box 1 (Figures 5–7) Qty
A. Model T32304 Saw Body ............................ 1
B. Stand Legs .................................................. 2
C. Stand Top .................................................... 1
D. Upper Brace ................................................ 1
E. Side Braces ................................................. 2
F. Motor Mount ................................................ 1
G. Stand Covers ............................................... 2
H. Motor
3
⁄
4
HP 120V 1-PH ............................... 1
I. V-Belt ........................................................... 1
J. Table ............................................................ 1
K. Retention Bracket ........................................ 1
L. Fence Shaft 305mm .................................... 1
M. Pusher Shaft 248mm ................................... 1
N. Fence........................................................... 1
O. Meat Pusher ................................................ 1
P. Meat Grinder Assembly w/Cover ................. 1
Q. Push Tool..................................................... 1
R. Sausage Stuffer ........................................... 1
S. Hardware ..................................................... 1
—Hex Bolts M8-1.25 x 20 .......................... 7
—Carriage Bolts M8-1.25 x 16 ................. 20
—Hex Nuts M8-1.25 ................................. 24
—Flat Washers 8mm ............................... 27
—Hex Bolts M6-1 x 20 ............................... 4
—Cap Screws M6-1 x 16 ........................... 6
—Cap Screws M6-1 x 10 ........................... 4
—Lock Washers 8mm ................................ 7
—Cable Holder ........................................... 1
—Support Brackets .................................... 2
—Lock Knobs ............................................. 2
—Rubber Feet ............................................ 4
A
B
C
D E
F
G H
I
J
K
L
M
N
O
P
Q
R
S