Model T30943/T30944 (Mfd. Since 10/19)
-13
-
Assembly
1. Mount coolant bottle as shown in
Figure 6.
Note: Make sure both pins beneath
coolant bottle are firmly seated in tool
frame so bottle is secure.
2. Attach coolant hose to spindle hous-
ing with pre-installed 90˚ elbow (see
Figure 6).
To assemble tool:
Test Run
3. Install (3) elevation levers on hub (see
Figure 7).
Figure 7. Levers installed on hub.
Hub
Lever
(1 of 3)
DO NOT start tool until all preced-
ing setup instructions have been
performed. Operating an improperly
set up tool may result in malfunc-
tion or unexpected results that can
lead to serious injury, death, or tool/
property damage.
Serious injury or death can result
from using tool BEFORE under-
standing its controls and related
safety information. DO NOT oper-
ate, or allow others to operate, tool
until information is understood.
Once assembly is complete, test run the
tool to ensure it is properly connected to
power and safety components are working
properly.
If you find an unusual problem during the
test run, immediately stop the tool, discon-
nect it from power, and fix the problem
BEFORE operating the tool again. The
Troubleshooting table in the SERVICE
section of this manual can help.
The test run consists of verifying the fol-
lowing: 1) The motor powers up and runs
correctly, and 2) the magnet works correctly.
Figure 6. Coolant bottle installed and
coolant hose attached.
Coolant
Bottle
Spindle
Housing
Coolant
Hose
Elbow
