Grizzly T27417, Owner'S Manual

Page: 18 / 44

-16-
Model T27417 (Mfd. Since 09/15)
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
4. Remove switch-disabling key, as shown in
Figure 14.
5. Try to start machine with paddle switch. The
machine should not start.
— If machine does not start, switch disabling
feature is working as designed.
— If machine does start, immediately stop
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Congratulations! The test run is complete.
The sander is ready for operation.
Figure 14. Removing switch key from paddle
switch.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly
2) The switch-disabling key safety feature works
correctly