For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
MODEL T26979
3-IN-1 WORKPIECE
SUPPORT STAND
INSTRUCTIONS
COPYRIGHT © JANUARY 2015 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
(FOR MODELS MFD. SINCE 06/14) #AW17097 PRINTED IN CHINA
Introduction
The T26979 3-in-1 Workpiece Support Stand will
support up to 250 lbs. It is adjustable from 27
1
⁄
2
"
to 43". The stand has a small footprint of 22" X
18". The stand has three positions: static, multi-
directional, and single plane.
Push lock knob to release leg, then extend leg
until it locks in open position.
Setup
Figure 1. Model T26979 controls and
components.
Lock
Knob
Leveling
Dial
Lock
Lever
Three-Position
Head
Lift up on head to disengage pivot stop, then
rotate head into positive stop at desired position.
Positive stop does not allow further movement.
(see
Figure 2).
Note: To prevent pinching, use two hands and lift
from outside of head.
V1.01.15
1. Turn lock lever counterclockwise to adjust
head to needed height.
2. Turn lock lever clockwise to secure head in
place.
Adjusting Height
Push lock knob towards stand, then slide legs
towards each other to lock.
Collapsing Legs
Adjusting Head
Figure 2. Three head positions.
Static
Multi-Directional
Single Plane
