
For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
MODEL T10827
INDUSTRIAL HEAT GUN
INSTRUCTIONS
COPYRIGHT © NOVEMBER, 2014 BY GRIZZLY INDUSTRIAL, INC. REVISED MARCH, 2021 (BL)
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#WK16758 PRINTED IN CHINA
Introduction
The Model T10827 Industrial Heat Gun provides
a flow of heated air for applications such as paint
stripping, bending and molding plastics, shrink
wrapping, and drying adhesives. The adjustable
stand supports the heat gun, allowing both hands
to hold the workpiece in the hot airflow. Read all
instructions and safety material before operating
the heat gun.
To adjust the amount of heat applied to your work-
piece, adjust the air intake shutter, the distance
between the nozzle opening and the workpiece,
and the length of time heat is applied to the work-
piece.
To operate heat gun:
1. Make sure rocker switch (see Figure 1) is set
to OFF.
2. If using adjustable stand, thread stand into
one of three mounting holes on heat gun
body.
3. Adjust air intake shutter (see Figure 1) to
desired position. Opening shutter provides
slightly cooler air. Closing shutter provides
the highest temperature.
4. Plug heat gun into power supply.
5. Move rocker switch to HOT position, and wait
approximately 2 minutes for it to reach oper-
ating temperature before beginning heating
operation.
6. When finished with heating operation, move
switch to COLD position and allow heat gun
to run for 2–3 minutes to cool off.
7. Move rocker switch to OFF position.
Operation
Figure 1. Model T10827 controls and major
components.
Specifications
Power Requirement .. 120V, Single-Phase, 60 Hz
Full-Load Amp Draw ................................... 12.5A
Minimum Circuit Size ..................................... 15A
Temperature Range ...................... 122°F–1022°F
Cord ............................................................... 6 ft.
Plug ................................................... NEMA 5-15
Weight ..................................................... 3
1
⁄
2
lbs.
V1.03.21
Air Intake
Shutter
Rocker
Switch
Stand