Grizzly H8192, Owner'S Manual

Page: 24 / 36

-22-
Model H8192 1" Belt/8" Disc Combo Sander
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious personal
injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Before Each Use, Check and Correct:
• Loose mounting bolts.
• Damaged or worn sanding belt or disc.
• Worn or damaged wires.
• Any other unsafe condition.
After Each Use:
• Clean/vacuum dust buildup on tables and
motor.
After 50 Hours of Use:
• Check and correct V-belt tension, damage, or
wear.
Schedule
Cleaning the Model H8192 is relatively easy.
Vacuum excess sawdust, and wipe off the
remaining dust with a dry cloth. Wiping the table
clean after every use ensures moisture from wood
dust does not remain on bare metal surfaces.
If any resin has built up, use a resin dissolving
cleaner to remove it. After cleaning, treat all
unpainted cast iron and steel with a non-staining
lubricant with products like G96
®
Gun Treatment,
SLIPIT
®
, or Boeshield
®
T-9.
Cleaning
Lubrication
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. Do not lubricate them.
Sanding Belt
Tracking
The sanding belt must track in the center of the
top pulley to avoid damaging itself during use.
To adjust the sanding belt tracking:
1.
Turn the sander
ON
.
2.
Observe the sanding belt as it moves over
the top pulley (see Figure 31 ).
Figure 31. Sanding belt tracking adjustment.
Top Pulley
Tracking
Adjustment
Knob
3. Slowly adjust the tracking adjustment knob
until the sanding belt tracks in the center of
the top pulley.
Belt Tracking