Introduction
No load speed is 20,000 RPM and collet size is
1
⁄
4
". Requires maximum of 90 PSI with a minimum
of 4 CFM compressor capacity. Air inlet is
1
⁄
4
" and
air exhaust is in the rear. Weighs 1.2 lbs.
Inventory
A. Die Grinder ................................................. 1
B. Wrenches ................................................... 2
Operation
Insert your
1
⁄
4
" shank tool into the collet. Using the
two wrenches, secure tool by tightening the collet
nut against the spindle.
MODEL H0589
1
⁄
4
" AIR DIE GRINDER
INSTRUCTION SHEET
Figure 1.
Model H0589.
Figure 2.
Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
CoPyRIGHt © FebRUARy, 2006 by GRIzzLy INDUStRIAL, INC. RevISeD SePteMbeR, 2009 (bL)
WARNING: NO pORTION OF THIS MANUAL MAy BE REpRODUCED IN ANy SHApE
OR FORM WITHOUT THE WRITTEN AppROvAL OF GRIzzLy INDUSTRIAL, INC.
#PC8027 PRINteD IN tAIWAN
Die Grinder MUSt have 3-4 drops of oil directly
dropped into the air fitting before each use as
shown in
Figure 2.
INJURy HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EyE/EAR INJURy HAzARD!
Wear safety glasses and
hearing protection during
use of this tool!
RESpIRATORy HAzARD!
Grinding produces fine
dust. Wear the appropriate
protection during use!
EXpLOSION HAzARD!
Never exceed 90 pSI! Always
use accessories with correct
speed rating.