Introduction
Angle Die Grinders are excellent for reaching
sideways into areas that are relatively confined.
No-load speed is 18,000 RPM and collet size is
1
⁄
4
". Requires 90 PSI with 4 CFM of compressor
capacity. Air inlet is
1
⁄
4
" and air exhaust is in the
rear. Weighs just over 1 lb.
Inventory
A.
Die Grinder ................................................. 1
B.
Flat Wrench 17mm ..................................... 1
C.
Flat Wrench 12mm ..................................... 1
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in
Figure 2
. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in
Figure 3
.
MODEL H0588
1
⁄
4
" ANGLE DIE GRINDER
INSTRUCTION SHEET
Figure 1.
Model H0588.
Figure 3.
Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#KM7957 PRINTED IN TAIWAN
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
EXPLOSION HAZARD!
Never exceed 120 PSI.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2.
Installing your tool.
