For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
MODEL G5956
REMOTE CONTROL
SWITCH FOR G5955
INSTRUCTIONS
Copyright © MAy, 2011 By grizzly industriAl, inC.
WaRNING: NO pORTION OF THIS MaNUaL May bE REpRODUCED IN aNy SHapE
OR FORM WITHOUT THE WRITTEN appROvaL OF GRIzzLy INDUSTRIaL, INC.
#ts14115 printed in tAiWAn
Figure 1. Model g5956 remote control and
switch.
switch
remote
Control
Introduction
the Model g5956 remote Control switch is
designed to work with the Model g5955 hanging
Air Filter. With this unit installed, you can control
the air filter from anywhere in your shop.
Installation
1. disConneCt Air Filter FroM poWer!
2. remove the four screws and detach the con-
trol switch panel from the back of the hanging
air filter (see
Figure 2).
Figure 2. installing the remote switch.
switch Mounting
screw locations
3. Attach the switch to the switch panel with
the two screws provided in the panel (see
Figure 2).
4. locate the two cables with sockets on the
ends inside the air filter and connect them to
the switch cables.
Note: These cable sockets are unique and
can only be connected one way.
5. re-install the switch panel to the air filter and
secure it with the four screws removed in
Step 2.
Specifications
Battery type ............................................... 9 Volt
transmission type ....................radio Frequency
Country of origin ...................................... taiwan
