Grizzly G1071, Owner'S Manual

Page: 24 / 40

-22-
Model G1071 (Mfd. Since 11/10)
Sanding Sleeves
The Model G1071 is supplied with 10 sanding
sleeves. Use coarse grits for fast material removal
and a rough finish. Use fine grits for slower mate-
rial removal and a smoother finish. When chang-
ing from a coarse sleeve to a finer sleeve on a
particular sanding project, avoid increasing the
grit number by intervals of more than 50.
To change the sanding sleeve on spindles
larger than
5
⁄
8
":
1. DISCONNECT MACHINE FROM POWER!
2. Loosen the hex nut located on the top of the
spindle as shown in Figure 22. The hex nut
and flange disk DO NOT need to be removed.
NOTICE
Monitor the wear on the sanding sleeves.
The upper portion of the sanding sleeve
often gets very little use. If this is the case,
flip the sanding sleeve over and re-install.
This allows maximum use of the sleeve.
Worn sanding sleeves will not efficiently
remove material and can burn the wood.
Figure 22.
Removing sanding sleeve.
3. Slide the sanding sleeve from the spindle .
4. Reverse Steps 1–2 to install a sanding
sleeve.
3. Slide the sanding sleeve from the spindle .
4. Reverse Steps 1–2 to install a sanding
sleeve.
To change the sanding sleeve on spindles
5
⁄
8
"
and smaller:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen the set screw located in the retainer
nut (see
Figure 23).
Figure 23.
Retainer nut set screw.