Grizzly G1071, Owner'S Manual

Page: 19 / 40

Model G1071 (Mfd. Since 11/10)
-17-
13. Thread four of the
1
⁄
4
"-20 x
5
⁄
8
" set screws into
the threaded holes on each table insert, as
shown in
Figure 15.
Note: The roll pins and set screws must
not protrude above the top surface of the
table insert or they will interfere with sanding
operations.
Figure 15.
Inserting set screws.
Flat Top Surface
Set Screws
Roll Pin
Table Insert
Table Insert
Set Screw
(1 of 4)
Check Gearbox Oil
It is critical that you make sure there is oil in the
gearbox before proceeding with the test run.
Remove the spindle gearbox oil fill cap and use
the dipstick to make sure the oil level is full. When
full, the oil will read on the knurled portion of the
dipstick.
Refer to Gearbox Oil on Page 28 for more infor-
mation on gearbox lubrication, which type of oil to
use, how much to use, and where to put it.
After first two hours of operation, perform an
oil change as described in the
Gearbox Oil on
Page 28.
GEARBOXES MUST
BE FILLED WITH OIL!
NO OIL SHIPPED WITH
MACHINE!
Requires 80W–90W
or Equivalent
Gear Oil.