Model G0900 (Mfd. Since 03/20)
-49-
Figure 70. Gib adjustment settings location.
Zeroing Out Fence
The G0900 features forward and backward
spindle rotation; either fence face can function as
the infeed or outfeed fence. However, the scales
indicating the fence face placement on the fence
assembly need to be accurately calibrated to
allow for accurate micro-adjusting. The factory
made these adjustments during production, but
you may need to adjust the settings if they have
been altered.
Tools Needed
Qty
Hex Wrench 3mm .............................................. 1
Socket or Wrench 10mm ................................... 1
To calibrate scales:
2. Loosen gib adjustment set screws and hex
nuts on fence or fences that do not display 0"
(see
Figure 70).
— If fence scales both indicate 0", no calibra-
tion is required.
— If fences display different measurements
on scales, proceed to the following steps
to calibrate.
3. Use fence micro-adjusment knobs to adjust
fences until 0" measurement is achieved on
both sides.
4. Tighten gib adjustment hardware to secure
setting.
1. Unlock both fence lock handles and turn both
microadjustment knobs fully counterclock-
wise (see
Figure 70).
Lock Handle
Gib Adjustment
Hardware
Micro-Adjustment
Knob
5. Proceed to Aligning Fence Faces to ensure
fence faces are parallel.
Zeroing Out Fence Steps
Summary of Contents for G0900
Page 68: ......
