Grizzly G0900, Owner'S Manual

Page: 20 / 68

-18-
Model G0900 (Mfd. Since 03/20)
Assembly
Most of your Model G0900 has been assembled
at the factory, but some parts must be assembled
or installed after delivery.
In order to perform a test run, verify the
following:
1. Table insert flushness (this page).
2. Spindle and drawbar assembly (Page 19).
3. Dust collection system connection (Page 20).
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
The Model G0900 is supplied with three table
inserts which give you four possible opening
diameters in the shaper table surface. Use the
smallest opening that a particular cutter will allow
to support the workpiece and reduce the amount
of chips that can fall into the machine.
The correct spindle opening will also allow any
unused portion of the cutter to remain below the
table surface—increasing operator protection.
There are two removable table inserts and one
semi-permanent table insert. The semi-perma-
nent table insert must be flush with the top of the
table.
To adjust insert:
1. Remove two smaller inserts from table
opening.
2. Lay straightedge across semi-permanent
insert and table surface in pattern shown in
Figure 13 .
Figure 13. Straightedge and surface pattern.
Straightedge
Table Insert
Table Surface
+
+
+
Phillips Head
Screws (1 of 3)
Adjusting
Table Inserts
3. Adjust phillips head screws so that ends of
straightedge lay flat on table surface at all
positions of pattern above.
IMPORTANT:
Table insert and surface must
be aligned evenly to ensure workpiece does
not catch on table insert or surface and kick
back.