Grizzly G0900, Owner'S Manual

Page: 16 / 68

-14-
Model G0900 (Mfd. Since 03/20)
Figure 7. Shaper unit.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 7) Qty
A. Shaper Unit ................................................ 1
Box 2 (Figure 8) Inside Cabinet Qty
B. Miter Gauge ................................................ 1
C. Drawbar ...................................................... 1
D. Starting Pin ................................................. 1
E. Table Featherboards .................................. 2
—Knob Bolts M5-.8 x 25 ............................ 2
—Flat Washers 5mm.................................. 2
—Sliding Blocks ......................................... 2
F. Spindles
3
/
4
" w/Spacers .............................. 1
G. Spindles 1
1
/
4
" w/Spacers ............................. 1
H. Spindle Wrench 50mm ............................... 1
I. Combo Screwdriver .................................... 1
J. Hex Wrenches 3, 6mm .........................1 Ea.
K. Open-End Wrench 22 x 24mm ................... 1
L. Open-End Wrench 14 x 17mm ................... 1
A
Figure 8. Small parts inventory.
B
C
D
E
F
G
H
I
J
K
L