Grizzly G0898, Owner'S Manual, Page: 26 / 40

-24-
Model G0898 (Mfd. Since 12/19)
Slack grinding is positioned similarly to flat grind-
ing, but with the platen removed. This is most use-
ful for contour sanding where the belt conforms to
the shape of the workpiece.
Slack Grinding
To perform slack grinding:
1. DISCONNECT MACHINE FROM POWER.
2. Remove (2) cap screws and flat washers
shown in Figure 33 to remove platen.
Figure 33. Cap screws securing platen.
4. Connect machine to power, turn it ON, and
allow it to reach full speed.
5. Position workpiece against work table/rest if
feasible, then slowly feed it into moving belt
with light, even pressure (see
Figure 36).
Move workpiece to different locations to wear
sandpaper evenly and to prevent it from over-
heating.
Figure 36. Proper slack grinding.
3. Loosen cap screw shown in Figure 34, adjust
wheel guard until it lightly contacts belt (see
Figure 35), then tighten to secure.
Figure 35. Contact wheel guard positioned to
support belt.
Contact Wheel
Guard Screw
Figure 34. Contact wheel guard position lock
screw.
Belt
Contact Wheel
Guard
Platen Adjustment
Cap Screws