Grizzly G0898, Owner'S Manual, Page: 17 / 40

Model G0898 (Mfd. Since 12/19)
-15-
Serious injury could occur if you connect
machine to power before completing setup
process. DO NOT connect to power until
instructed later in this manual.
Assembly
To assemble machine:
1. Mount machine to bench as described in
Bench Mounting on Page 14.
2. Loosen both cap screws shown in Figure 13,
but do not remove.
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Figure 13. Wheel guard and work table position
cap screws.
Work Table
Position Screw
Contact Wheel
Guard Screw
5. Pull belt tension lever backward (see Figure
16), then slide included sanding belt over
wheels and platen.
Figure 15. Belt access door knob.
Belt Access
Door Knob
Figure 16. Lever positioned without tension.
Belt Tension
Lever
4. Unscrew belt access door knob to open door
(see Figure 15).
3. Loosen grinder tilt lock screw (see Figure
14). Adjust grinder to upright position, then
tighten screw to secure.
Figure 14. Grinder tilt lock screw.
Grinder Tilt
Lock Screw
Platen
Wheels