-32-
Model G0889/G0889Z (Mfd. Since 12/18)
SECTION 6: MAINTENANCE
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Ongoing
To maintain a low risk of injury and proper
machine operation, if you ever observe any of the
items below, shut down the machine immediately
and fix the problem before continuing operations:
•
Loose mounting bolts.
•
Damaged knives/inserts.
•
Worn or damaged wires.
•
Any other unsafe condition.
Monthly Check
•
Clean chains and sprockets of dust, wood
chips, and old grease.
•
Lightly coat chains and sprockets with NLGI#2
grease (see
Page 33).
•
Lubricate elevation leadscrews with spray
lubricant (see
Page 31).
•
Check V-belt for tension, damage, or wear
(see
Page 36). Also, ensure belt is clean and
free of oil or grease that could cause it to slip.
•
Remove cutterhead guard and fan cover, and
thoroughly clean built-up sawdust and chips.
Schedule
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Cleaning the Model G0889/G0889Z is relatively
easy. Vacuum excess wood chips and sawdust,
and wipe off the remaining dust with a dry cloth.
If any resin has built up, use a resin-dissolving
cleaner to remove it.
Cleaning &
Protecting
There are four primary systems that require peri-
odic lubrication: the cutterhead elevation lead-
screws, the feed roller chain drive, the table height
chain, and columns. Clean the components in this
section with an oil/grease solvent cleaner or min-
eral spirits before applying lubrication.
Items Needed
Qty
Stiff Brush .......................................................... 1
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
Grease NLGI#2 ................................. As Needed
Hex Wrench 4mm .............................................. 1
Lubrication
Grease Type ................ G4682 Dry Coating Lube
Frequency ................................................Monthly
Elevation Leadscrews & Columns
Summary of Contents for G0889
Page 52: ...50 Model G0889 G0889Z Mfd Since 12 18...
Page 56: ......
