Model G0885 (Mfd. Since 04/19)
-23-
The speed at which the saw blade will cut through
a workpiece is controlled by the blade type and
feed rate. The feed rate is controlled by how hard
the user pulls the saw down into the material.
The feed rate should be proportional to the speed
of the saw. Allow the blade to remove chips as
it cuts through the material. Here are some signs
that the feed rate is too fast.
• Saw binding in cut and motor slows down.
• Saw blade flexing as it moves through cut.
Feed Rate
Always turn saw OFF and allow blade to
come to complete stop before adjusting
vise! Failure to follow this caution may lead
to injury.
Vise
The vise allows the jaw width to be adjusted up
to 5" wide.
1. Turn vise handle (see Figure 23) counter-
clockwise to relieve any pressure on vise
jaws.
Using Vise
2. Place workpiece flat on the vise table.
3. Finish tightening movable jaw against
workpiece with vise handle.
Note: Figure 24 on Page 24 shows correct
methods of holding different workpiece
shapes.
The Model G0885 is equipped with a work stop
that can be used to quickly position the workpiece
during a repetitive cutting operation. Adjust the
work stop as needed, then tighten the lock handle
to secure it in place, as shown in
Figure 22.
Work Stop
Figure 22. Setting work stop to support repetitive
cutting operation.
Work Stop
Lock
Handle
Figure 23. Location of vise components.
Vise
Handle
Moveable
Jaw
Vise Base
Summary of Contents for G0885
Page 40: ......
