-44-
Model G0866 (Mfd. Since 11/18)
Cleaning
Sanding Belt
To increase the working life of your sanding belts,
clean them whenever they decrease in perfor-
mance due to heavy loading of material. Use a
Model D3003 PRO-STIK
®
Cleaning Pad as shown
in
Figure 71.
The air system is durable and reliable; however,
components do wear with age. If you suspect that
an item in your pneumatic system may be having
problems, see the
Pneumatic System Diagram
on
Page 66.
•
Adjust regulator to approximately 75 PSI.
•
Carefully inspect all air lines for cracks, chaf-
ing, or hardening. Replace faulty hoses.
•
Check air connections for leaks. A small
amount of soapy water in a questionable area
will bubble if there is a leak.
•
Make sure lines are not clogged. Remove
a questionable line and blow through it as a
test.
Pneumatic System
Figure 71. PRO-STIK cleaning pad in use.
To clean sanding belt:
1. Set table to thickness of cleaning pad.
2. Run pad through sander two or three times.
DO NOT take too deep of a cut—belt should
barely touch cleaning pad.
Summary of Contents for G0866
Page 100: ......