Grizzly G0866, Owner'S Manual, Page: 64 / 100

-62-
Model G0866 (Mfd. Since 11/18)
14. Install eccentric tube and tighten cap screws
to secure.
15. Install bearing housing and secure with hex
bolts and washers removed in
Step 11.
16. Install square frame end and securing Phillips
head screws, then replace cap screws
removed in
Step 9.
17. Remove wood blocks supporting rollers.
18. Properly tension V-belts (refer to Checking/
Adjusting V-Belt Tension on Page 59 for
more information).
19. Close and secure right access panels.
Figure 112. Location of drum and motor pulleys.
Motor Pulleys
Rubber Roller
Pulleys
12. Remove bearing housing to access right rub-
ber roller pulley and remove old V-belt.
13. Place new set of V-belts onto rubber roller
pulleys and then loop other end of V-belts
around motor pulleys (see
Figure 112).
Figure 111. Location of bottom bearing housing
hex bolts and washers.
x 4
11. Remove (8) hex bolts and flat washers secur-
ing bearing housing in place (see Figures
110–111).
Figure 110. Location of top bearing housing hex
bolts and washers.
Bearing Housing
x 4
Adjusting Conveyor
Belt Tension
The conveyor belt tension has been adjusted at
the factory and should require no further atten-
tion. However, adjust the conveyor belt tension if
you notice that your conveyor belt is slipping or is
tracking off center.
The conveyor belt tension is adjusted by rotating
two adjustment bolts, located on each side of the
conveyor table (see
Figure 113).
Figure 113. Location of conveyor belt adjust-
ment bolts (1 of 2 shown).
Conveyor
Belt
Adjustment
Bolt
(1 of 2
Shown)
Tool Needed: Qty
Open-End Wrench 19mm ...................................1