Model G0866 (Mfd. Since 11/18)
-43-
Feed Belt Gearbox
Oil Type .................... T28042 or ISO-VG 320 Oil
Oil Amount ......................................... As Needed
Frequency .... After first 300 hrs., every 2500 hrs.
If gearbox oil is low, remove fill plug (see
Figure 68)
and all new oil until sight glass is full, then re-
install fill plug.
If gearbox oil needs to be changed, run machine
to warm gearbox before removing fill plug and
drain plug (see
Figure 68), draining oil, then re-
installing drain plug. Add new oil until sight glass
is full, then re-install fill plug.
Figure 68. Gearbox lubrication components.
Fill Plug
Sight Glass
Drain Plug
Items Needed
Qty
Drain Pan ........................................................... 1
Wrench 14mm ................................................... 1
Emptying Dust and
Water Traps
Three collection traps on this sander need to be
emptied regularly. DO NOT allow any of these
traps to become full or you risk serious damage
to your machine.
The air pressure regulator water trap (see
Figure
69) is attached to the air pressure regulator and
traps condensation in the incoming air supply.
With the system under air pressure, push the
lower drain valve and empty the regulator water
trap (see
Figure 69). Replace the internal white
moisture filters annually.
Figure 69. Location of regulator water trap and
drain valve.
Drain Valve
Regulator
Water Trap
There are two dust trap bowls inside the upper
right access panel (see
Figure 70). To empty
these, turn air pressure
OFF, allow pressure to
bleed out, then unscrew and empty bowls.
Figure 70. Location of dust cups.
Dust Trap Bowl
(1 of 2)
Summary of Contents for G0866
Page 100: ......