Model G0857/G0858 (Mfd. Since 07/19)
-27-
Squaring Stock
Squaring stock involves four steps performed
in the order below:
1. Surface Plane on Jointer—Concave face of
workpiece is surface planed flat with jointer.
Previously Surface
Planed Face
2. Surface Plane on a Thickness Planer—
Opposite face of workpiece is surface planed
flat with a thickness planer.
3. Edge Joint on Jointer—Concave edge of
workpiece is jointed flat with jointer.
15
30
45
Previously
Jointed
Edge
4. Rip Cut on a Table Saw—Jointed edge
of workpiece is placed against a table saw
fence and opposite edge cut off.
Squaring stock means making it flat and paral-
lel along both length and width, and making the
length and width perpendicular to one another.
The purpose of squaring stock is to prepare it for
accurate cuts and construction later on.
A properly "squared up" workpiece is essential
for tasks such as accurate table saw cuts, glue-
ups/laminations, cutting accurate bevels on a
bandsaw, and many other applications where
one surface of a workpiece is used to reference
another.
Items Needed
Qty
Jointer ................................................................ 1
Planer ................................................................ 1
Table Saw .......................................................... 1
Summary of Contents for G0857
Page 65: ......
