Model G0853 (Mfd. Since 07/18)
-59-
Crosscut
Table
Crosscut
Fence
Inside
Position
Crosscut
Table
Outside
Position
Crosscut
Fence
Figure 109. Inside and outside support bar
positions.
Setting Up
Crosscut Fence
Before using the crosscut fence to perform cutting
operations, it must be set up properly. This
includes positioning the crosscut fence on the
crosscut table, adjusting the support bar, adjusting
the crosscut fence distance from the blade, and
positioning the crosscut table along the sliding
table.
The crosscut fence can be mounted in the front
or rear position (see
Figure 108) depending upon
the size of the workpiece and which position will
provide the safest operation. The support bar
is adjusted accordingly for maximum workpiece
support.
Front
Position
Crosscut
Table
Support
Bar
Rear
Position
Crosscut
Table
Support
Bar
Figure 108. Crosscut fence front and rear table
mounting positions.
Whenever the crosscut fence is moved between
the front and rear positions, you must verify the
fence is square to the blade, and the 0° stop bolts
are properly adjusted before using the fence.
Refer to
Squaring Crosscut Fence to Blade on
Page 95 for further details.
Positioning Crosscut Fence
To position crosscut fence:
1. DISCONNECT MACHINE FROM POWER!
2. Remove pivot knob and angle scale knob
shown in
Figure 110, and release latch
securing 0° stop block.
The support bar can also be installed in either the
inside or outside positions (see
Figure 109).
Figure 110. Locations of knobs and latch
securing crosscut fence to table.
Pivot Knob
Latch
Angle
Scale Knob
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
